Step by step installation

More photos at bottom of page.

Loop through your gear/rack

Loop through your gear/rack – Take the theft deterrent by the end with the loop, place this through your bikes wheel or frame or loop round the upper arm of your Piste/Tidal rack. Now take your ball stop and feed through the loop. Pull until the cable is firmly looped around your gear.

Position the ball stop

Feed the ball stop into your boot, placing the ball stop in the middle of the boot floor. Ensure the cable will not block or be tangled with the boot mechanism.

Anchor

With the deterrent looped through your gear and the ball stop in the boot, you can now close the boot. This will secure the cable as the ball stop will not be able to removed and the loop around your gear will not be able to be removed either until the boot is opened again.

How to remove the Theft Deterrent

Removing the Theft Deterret

To remove the theft deterrent and free your gear simply open your boot and undo the loop around your gear. Follow the above steps in reverse to free your equipment.

Transport your equipment.

1 4