Step by step installation

Placing Tidal on your vehicle

Take both Tidal mounts with vacuum cups attached and place on the roof of the car width ways. Space the mounts accordingly for the board/item you’ll attach to Tidal. Bare in mind the size of the board when doing this step.

Fixing Tidal to your vehicle

Now Tidal is positioned appropriately for the load and vehicle we can fix tidal to the car. To do this you will need to pump the plunger on the side of each vacuum cup. Once the yellow band on the side of the plunger disappears, the vacuum cup is secure. Repeat this with all 6 vacuum cups.

Placing your board on Tidal

Place your board on Tidal so that when resting it is balanced evenly between the two Tidal mounts. Your board should be facing forwards and in the direction of travel of the vehicle.

Fixing your board to Tidal

Using the two supplied straps you need to wrap each strap in a figure of eight around the board and tidal on both the front and rear mount. This should be repeated as many times possible with the length of strap provided. There should be no movement between the board and Tidal.

How to remove Tidal

Remove your board

Release the clasp on each strap to untie the board to Tidal, you can then lift your board off of Tidal.

Remove Tidal

lift the lift tab on each of the vacuum cups. This will release the vacuum and allow you to remove Tidal from your vehicle

1 3

Transport your equipment.

View all
1 4
View all